Annke Default DVR Passwords
This page lists 2 confirmed default credentials for Annke equipment, covering 2 models. The pairing you are most likely to need is admin with a password you set at first login.
Entries are reachable over multi and console.
admin2 of 2 entries| Model | Protocol | Access | Username | Password |
|---|---|---|---|---|
| ANNKE VISION DVR/NVR (DT/DN/DW SERIES, N44PI, N48PI, NCK800, H500, H800) | MULTI | Admin | admin | you create this on first boot |
| XMEYE/XIONGMAI-BASED DVR/NVR (DN81BJ, DH81NK, DM21O, DG41T AND SIMILAR) | CONSOLE | Admin | admin | no password set |
About Annke
The entries are logged as digital video recorders. 2 distinct Annke models are covered.
Reaching the login page
Point a browser at whatever your computer reports as its default gateway. On Windows that is the Default Gateway line from ipconfig; on macOS, Network settings shows it under the active connection.
What the Annke defaults look like
Every entry uses the username admin. One model shipped with no password at all.
If the Annke password has already been changed
Cameras and recorders rarely have an accessible reset button. On a camera it is usually a small switch on the pigtail or under the dome that has to be held while power is applied. On a recorder the reset is normally a jumper or a button on the mainboard, which means opening the case. Several manufacturers will also generate a one-time unlock code from the device serial number and the current date if you contact their support with proof of ownership.
A reset on a recorder wipes the camera list, the recording schedule and the network settings, though it leaves the footage on the disks alone. Write down the IP addresses of the cameras first, because re-adding them one at a time is the slow part.
Share This Page