i-PRO (Panasonic) Default Camera Passwords
This page lists 1 confirmed default credential for i-PRO (Panasonic) equipment. The pairing you are most likely to need is (set at setup) with (set at setup).
Entries are reachable over http. All of these entry use a protocol that sends the password in clear text, so use them on a trusted network and change the password once you are in.
(set at setup)(set at setup)| Model | Protocol | Access | Username | Password |
|---|---|---|---|---|
| NETWORK CAMERAS (WV- AND S-SERIES) | HTTP | Admin | you choose this on first boot | you create this on first boot |
About i-PRO (Panasonic)
The entries are logged as CCTV cameras and recorders. The single record we hold is for the NETWORK CAMERAS (WV- AND S-SERIES).
Reaching the login page
Point a browser at whatever your computer reports as its default gateway. On Windows that is the Default Gateway line from ipconfig; on macOS, Network settings shows it under the active connection.
If the i-PRO (Panasonic) password has already been changed
Cameras and recorders rarely have an accessible reset button. On a camera it is usually a small switch on the pigtail or under the dome that has to be held while power is applied. On a recorder the reset is normally a jumper or a button on the mainboard, which means opening the case. Several manufacturers will also generate a one-time unlock code from the device serial number and the current date if you contact their support with proof of ownership.
A reset on a recorder wipes the camera list, the recording schedule and the network settings, though it leaves the footage on the disks alone. Write down the IP addresses of the cameras first, because re-adding them one at a time is the slow part.
Share This Page