Pacific Micro Data Default Router Passwords
This page lists 1 confirmed default credential for Pacific Micro Data equipment. The pairing you are most likely to need is pmd with no password at all.
Entries are reachable over console.
pmd| Model | Protocol | Access | Username | Password |
|---|---|---|---|---|
| MAST 9500 UNIVERSAL DISK ARRAY Rev. ESM VER. 2.11 / 1 | CONSOLE | Admin | pmd | no password set |
About Pacific Micro Data
The single record we hold is for the MAST 9500 UNIVERSAL DISK ARRAY.
Reaching the login page
Point a browser at whatever your computer reports as its default gateway. On Windows that is the Default Gateway line from ipconfig; on macOS, Network settings shows it under the active connection. None of the Pacific Micro Data entries here are for a web interface — they are reached over console, which means a terminal or a serial console rather than a browser.
If the Pacific Micro Data password has already been changed
This is not hardware you reset with a paperclip. Recovery runs through the console port: interrupt the boot sequence, tell the bootloader to ignore the saved configuration, start up, read or clear the password, then save and reboot. The exact key sequence differs by platform and is in the vendor documentation under password recovery.
You need physical access and a serial cable for this, which is deliberate. Anything reachable only over the network cannot be recovered this way.
Share This Page