Entrust Default Router Passwords
This page lists 1 confirmed default credential for Entrust equipment. The pairing you are most likely to need is websecadm with changeme.
Entries are reachable over web admin gui.
websecadmchangeme| Model | Protocol | Access | Username | Password |
|---|---|---|---|---|
| GETACCESS Rev. 4.X AND 7.X | WEB ADMIN GUI | Admin | websecadm | changeme |
About Entrust
The single record we hold is for the GETACCESS.
Reaching the login page
Point a browser at whatever your computer reports as its default gateway. On Windows that is the Default Gateway line from ipconfig; on macOS, Network settings shows it under the active connection. None of the Entrust entries here are for a web interface — they are reached over web admin gui, which means a terminal or a serial console rather than a browser.
If the Entrust password has already been changed
This is not hardware you reset with a paperclip. Recovery runs through the console port: interrupt the boot sequence, tell the bootloader to ignore the saved configuration, start up, read or clear the password, then save and reboot. The exact key sequence differs by platform and is in the vendor documentation under password recovery.
You need physical access and a serial cable for this, which is deliberate. Anything reachable only over the network cannot be recovered this way.
Share This Page